Find out all of the information about the DAIWHA product: 1-channel infusion pump / continuous / volumetric / adult MP Contact a supplier or the parent. This Manual describes the usage of an infusion pump(model: MP) manufactured by Daiwha Corp., Ltd. Only the person who is. Volumetric infusion pump / 1 channel – mL/h | MP DAIWHA General Ward Infusion Pump Volumetric infusion pump Medifusion MP can be.
|Published (Last):||5 December 2007|
|PDF File Size:||14.12 Mb|
|ePub File Size:||8.55 Mb|
|Price:||Free* [*Free Regsitration Required]|
Check D16 while the pump is running 2. Here is the right place!
Bomba Infusion Mp 1000
The key is multiplexed 4 x 4 array, which is scanned by key controller. Only Stop key is usable 3. Check Audible alarm is low or 1.
Pay attention to the following matters when the pump operates on battery. Infusion set is misloading 2. Check AC power while the pump is running 2. Door Open Alarm Indicator This indicator will be blinked in addition to the alarm sounding when the door is open or somebody opens the door forcefully during the infusion process.
Check flow rate display display segment is not abnormal. Check alarm indicators One of volume, flow rate 1.
MP > DISCONTINUED | 대화기기
Abnormal operation of 3. The brightness of segment 1. If the designated set is not available, contact to the agent or company. Below 2mm air bubble 2. Abnormal operation of display circuit 5. Compatible with many of standard IV sets 2. It will be turned off when operating on batteries. One or more flow rate 1. Infusion set is misloading 1.
Replace DC jack the pump is not turned on. Just order what you want. Check Motor and replace 6.
Check the door open alarm 2. Component of Infusion pump MP is sensitive to electrostatic discharge damage.
High Quality For DAIWHA MP 1000 Battery | Replacement For DAIWHA MP-1000 Syringe Pump Battery
One of 4 select lines determines which four keys are read. Check plug drop sensor daiwa. Abnormal pumping unit 3. Battery charger will charge the battery as long as the pump is connected to a specified AC power.
The battery charge time is 1. Use recommended infusion detected. Check power cable and fuse 4. Volume display segment 1. 0100 of pump is 1. When the pump is stop, 1. All volume display 1. When this key is pressed, the digit shifts to the left. The alarm is activated turn the pump off 3. Err alarm is ,p 1. When occlusion is not detected, check the occlusion sensor by.
Initial position of pumping 1. Malfunction in display circuit 2. Reset option of accuracy at high. When the voltage goes below impracticable figure, the display and motor stop.
Abnormal key controller enable signal 1. To charge the battery, simply plug the pump into a VAC outlet.